Use the stereo separation icon above to mono or stereo frequencies. Just enable solo and listen to the low, mid, high and master section once of your song to really hear where different sounds are living in your track before you decide to change anything or add any values. Enable solo & listen to the low, mid & high frequencies Sometimes when you hear your track at the end you will feel like the bass is not hard enough, my piano is not coming out enough or my vocals are too low this is where you tell those frequencies to come up or push them down. We use this plugin to push the low’s, mid’s & high’s up or down and fix the tonal imbalance even more. Usually, your tonal imbalance eq will look like this Let’s add Maximus Multiband Maximizer If you see any audio engineer increasing the mid frequencies in your master by too much tell them to give you your money back and go to some other engineer instead. I had to give you this warning in all caps because that is the biggest mistake most people make. Do Low & high pass cuts with high steep Insert your second EQ to start fixing the Tonal imbalanceĭO NOT PUSH THE NOBS IN THE MIDDLE BY TOO MUCH! Perform Low pass and high pass cuts with high steeps as told in the eq tutorial. Buy an original copy below (affiliate link) Load all plugins in the master chainĪlert: Imagine Line can track down illegal FL Studio accounts. If your mix did not create enough headroom you will need to go back to your mixing file and reduce the mixer by a few dB’s.Īnother thing to make note of is that all plugins we will load will be in the master chain of the mixer. This is where we take advantage of the dB’s wet cut in the mixing tutorial. Is there enough headroom? Check for headroom

Our end goal will be to fix the dynamic range & the tonal imbalance.

wav file, insert it into a new fl studio project file and let’s start mastering. Never do mastering in the same file you did your mixing in.

Fl mastering